#pragma once /* Central build-time hardware selection. See firmware/HARDWARE.md. * Select sensor and board independently; no credentials belong in this file. */ #define NANOPSX_SENSOR_SEN54 54 #define NANOPSX_SENSOR_SEN66 66 #define NANOPSX_BOARD_C6_DISPLAY_8MB 1 #define NANOPSX_BOARD_C6_DEVKIT_8MB 2 #ifndef NANOPSX_SENSOR #define NANOPSX_SENSOR NANOPSX_SENSOR_SEN66 #endif #ifndef NANOPSX_BOARD #define NANOPSX_BOARD NANOPSX_BOARD_C6_DISPLAY_8MB #endif /* SEN66 retains its known GPIO7/8 wiring. With a display the sole HP I2C * controller serves touch on GPIO18/19, so the sensor uses a GPIO bus. * SEN54 retains the existing shared hardware-bus wiring. */ #if NANOPSX_SENSOR == NANOPSX_SENSOR_SEN66 #define NANOPSX_SENSOR_SDA 7 #define NANOPSX_SENSOR_SCL 8 #else #define NANOPSX_SENSOR_SDA NANOPSX_I2C_SDA #define NANOPSX_SENSOR_SCL NANOPSX_I2C_SCL #endif #define NANOPSX_SENSOR_SOFT_I2C \ (NANOPSX_SENSOR_SDA != NANOPSX_I2C_SDA || NANOPSX_SENSOR_SCL != NANOPSX_I2C_SCL) #if NANOPSX_BOARD == NANOPSX_BOARD_C6_DISPLAY_8MB #define NANOPSX_BOARD_NAME "ESP32-C6 display / 8 MB" #define NANOPSX_HAS_DISPLAY 1 #define NANOPSX_I2C_SDA 18 #define NANOPSX_I2C_SCL 19 #elif NANOPSX_BOARD == NANOPSX_BOARD_C6_DEVKIT_8MB #define NANOPSX_BOARD_NAME "ESP32-C6 devkit / 8 MB" #define NANOPSX_HAS_DISPLAY 0 #define NANOPSX_I2C_SDA 7 #define NANOPSX_I2C_SCL 8 #else #error "Unsupported NANOPSX_BOARD: add a reviewed board profile first" #endif #define NANOPSX_I2C_PORT 0 #define NANOPSX_FLASH_BYTES 8388608 #if NANOPSX_SENSOR == NANOPSX_SENSOR_SEN54 #define NANOPSX_SENSOR_NAME "SEN54" #define NANOPSX_SENSOR_ADDRESS 0x69 #define NANOPSX_SENSOR_I2C_HZ 400000 #elif NANOPSX_SENSOR == NANOPSX_SENSOR_SEN66 #define NANOPSX_SENSOR_NAME "SEN66" #define NANOPSX_SENSOR_ADDRESS 0x6b #define NANOPSX_SENSOR_I2C_HZ 100000 #else #error "Unsupported NANOPSX_SENSOR: use SEN54 or SEN66" #endif /* Board profiles describe wiring/peripherals, not a replacement for the * PlatformIO chip, SDK configuration and partition-table selection. */ #ifdef ESP_PLATFORM #include "sdkconfig.h" #if !CONFIG_IDF_TARGET_ESP32C6 #error "These board profiles require ESP32-C6" #endif #if !CONFIG_ESPTOOLPY_FLASHSIZE_8MB #error "These board profiles require the 8 MB SDK/partition configuration" #endif #endif